go to text

Information on each factory

Information on each factory

Headquarters factory ≪Building C / Building E≫

Headquarters factory ≪Building C / Building E≫
In addition to the newly completed head office building, there are head office factory C building connected to the head office building, and D building alongside E and C buildings.
Building C was completed in October 2018, with a polishing section and additional process section on the 10st floor, a special needle manufacturing section on the 1nd floor, a cleaning section and a quality control section inspection section on the D building, and an inspection section on the 2st floor of the E building. Has special processing such as EMG grinding in the Additional Process Division, and the Quality Control Department, Production Engineering Department, and Development Department are located on the 1nd floor, and Building E is connected to Building C and the Headquarters Building on the 2nd floor.

Headquarters Factory ≪D Building / Wastewater Treatment Building≫

Headquarters Factory ≪D Building / Wastewater Treatment Building≫
The building on the left is Building D. Building D has a cleaning process and an inspection process.
The building at the back of the front is a wastewater treatment building equipped with the latest wastewater treatment equipment, and discharges wastewater that meets the regulated wastewater treatment standards to the river at a maximum of 10 t / h.Canula (injection needles) accepts materials at the Nogi factory, cuts them at the Tsukinukizawa factory, and ships about 7,000 million pieces every month from this head office building to Japan and the world.

Tsukinukizawa Factory << Building A / Building B >>

Tsukinukizawa Factory << Building A / Building B >>
The factory in front of the photo is Tsukinukizawa Factory Building B, and the factory in the back is Building A.
16 1-axis NC and 4-axis NC grinders are installed in Building A, 6 tapeless fully automatic NC grinders, 2 tapeless semi-automatic NC grinders and 7 honing shot blasting machines are installed in Building B. Installation and 2 alumina shot blasting machines and 1 fully automatic blasting machines are installed.
The fully automatic grinder operates in two shifts as needed.
The location is close to the head office and about 400m away.

Nogi factory

Nogi factory
The Nogi Factory, the former head office factory, is dispersed in five work buildings.
Material acceptance inspection of stainless steel pipes, pipe cutting and barrel polishing, taping processing, temper furnace annealing processing, mechanical chamfering processing, manual polishing processing and honing processing of small lots and special shapes, long materials, chemical polishing and special pickling work I am doing.
It is about 3km away from the head office.
 

Information inside the factory (↓↓ Please click the banner below)

Inspection department
Water Treatment Facility

Kaneko MediX, Inc.
〒329-2703
Tsukinukizawa 342-17, Nasushiobara City, Tochigi Prefecture
TEL.0287-36-6688
FAX: 0287-36-5827

───────────────
Manufacturing of medical injection needles
───────────────

 
Back to TOP